Permanent Power Switch
Unit
(DSU)
The way to switch digital (e.g. illuminations)!
- Permanent Power Switch Units
(DSU) can be connected directly to each output of
our Turnout Decoders QS-DEC-II and
S-DEC-4.
- Very easily you can now operate digitally turnout-lights or road-/ house-illuminations.
- As the Permanent Power
Switch Unit DSU
measures only 38 x 27 x 15 mm it can be very easily installed in
buildings etc.
- Simple and secure connection
to our Turnout Decoder S-DEC-4, QS-DEC-II and to any source
of lights by screw clips.
|
|
|
Permanent Power Switch DSU at the output 2 of the Turnout-Decoder S-DEC-4
for switching of turnout illumination. |
- If the Permanent Power Switch
DSU will be combined with the Turntable-Decoder
TT-DEC will at a 2-conductor turntable
bridge the polarity automatically changed at any 180 degree
turning.
|
|
|
Permanent Power Switch
DSU at the TurnTable-Decoder
TT-DEC for the turntable bridge polarity change on Fleischmann 2-conductor
turntables.. |
- A ready to use finished
module for a maximum load of up to 4A (two switch contacts
with up to 2A each).
- The permanent power switch
unit DSU is equipped with a bistable relay which
‘stores’ the short switch-over impulses of the turnout decoder
QS-DEC-II and S-DEC-4.
This allows the lights to be switched permanently on or off.
- Switch now the lights on your model railway
digitally for only €
9,90 for each Permanent Power Switch Unit.
- Order codes:
-
DSU (Part-No. 700012): Permanent Power Switch Unit
as a finished
module.
Subject to technical changes
and errors.
© 2008 by LDT