DSW-88

Data switch for the s88-feedback bus

from the Digital-Professional-Series !

The data switch DSW-88 acts as a Y-cable which can divide the s88-bus.
The above shown cable connects the module to the digital control unit and the two below s88-cables
are the two new s88-feedback lines, one to the right and one to the left side (see example above).

Normally the s88-feedback bus expects all connected feedback modules behind each others in one line. The new LDT data switch DSW-88 provides the possibility to split the s88-feedback output!

For example: Your digital central unit has been placed into the middle of the model railroad layout you do not need anymore to install a long feedback ring. You can now easily spilt the output after the data switch for a separate left  or right feedbackline.

Is the data switch DSW-88 connected directly to the digital central unit (here Intellibox) is it possible to build two feedback lines for left- and right-hand installation below the layout. If you require another splitting you can just insert one more data switch DSW-88 into the line.

 

  No additional power supply is required for the data switch DSW-88.

 

            The feedback informations will be transfered through the data switch without any delay.

 

  Each reading of feedback information started by the digital central unit will report the information of all connected feedback modules to the central unit. First reading will be the information of the left line. Following the data switch will change to the right feedback line for transfer of those informations.

 

  The data switch DSW-88 is compatible with all s88-feedback modules available on the market.

 

  LDT-components from the Digital-Professional-Series can easily be used on any digital model railway layout. The finished module and the finished module in a case comes with a 24 month warranty.

 

  Each data switch DSW-88 will be supplied with a detailed operating- / assembly instruction.

 

  The data switch DSW-88 is available as a kit, as checked finished module or as checked finished module in a case:

• Order codes:

DSW-88-B (Part-No. 040011): Data switch for the s88-feedback bus as a kit.

DSW-88-F (Part-No. 040012): Data switch for the s88-feedback bus as a finished module.

DSW-88-G (Part-No. 040013): Data switch for the s88-feedback bus as a finished module in a case.

 

We offer at low cost extension cables for the s88-feedback bus: under the order code Kabel s88 0,5m and Kabel s88 2m are at 0,5 respectively 2 meter length interference protected, twisted extension cables available for only € 5,50 respectively € 9,50 .

 

Subject to technical changes and errors

© 2008 by LDT